Page 1 of 1

Just made a 3D printed enclosure with fan for my Red Pitaya

Posted: Mon Jan 25, 2016 4:27 pm
by pvico
I just modeled and 3D printed an enclosure for my Red Pitaya.
All the details are here: https://dl.dropboxusercontent.com/u/986 ... losure.pdf
Enjoy !

Re: Just made a 3D printed enclosure with fan for my Red Pit

Posted: Mon Jan 25, 2016 10:22 pm
by Nils Roos
Good idea to have external screws for the shell and separate screws for the board.

Do you think PLA would break when inserting the nuts ?

Thanks for sharing !

Re: Just made a 3D printed enclosure with fan for my Red Pit

Posted: Mon Jan 25, 2016 10:56 pm
by pvico
No, probably not, might just be a bit harder to have the nuts seated correctly. It may also depend on your printer calibration. the hexagonal holes were designed 0.3 mm wider than the actual nut size. I have not used PLA recently and rely almost exclusively on PETG since months

Re: Just made a 3D printed enclosure with fan for my Red Pit

Posted: Mon Feb 15, 2016 9:03 am
by mnikolaos
Hi all,

Excellent work. However and as far as the fan is concerned, do you have any part number of Digikey or Mouser since I haven't manage to find this in local distributors/providers.

Re: Just made a 3D printed enclosure with fan for my Red Pit

Posted: Thu Nov 16, 2017 7:25 pm
by Mathias77
mnikolaos wrote:Hi all,

Excellent work. However and as far as the fan is concerned, do you have any part number of Digikey or Mouser since I haven't manage to find this in local distributors/providers.
Hello Mnikolaos,

If you don't know the part number you can search by a keyword or product name. You can check - https://www.icrfq.com/products/ here I hope you can find theirs by searching a product name which you needed. Thanks.