Hi all,
I just received my RP and I want to play with leds, pins and xadc using SCPI commands with putty.
I disabled the two services conflicting with the SCPI server and started the SCPI one. After that, I type things like "DIG:PIN LED2, 1" but it tells "command not found". How do I tell in the command prompt that I want to send these chars to the SCPI server?
Thanks.
Best regards
How to SCPI from putty?
-
- Posts: 1441
- Joined: Sat Jun 07, 2014 12:49 pm
- Location: Königswinter
Re: How to SCPI from putty?
Hi,
either you start a netcat session locally with "nc -k -C localhost 5000" on the console, or you start a second PuTTY and open a "raw" type connection to port 5000 on the RedPitaya's ip address. In both cases there will be no "redpitaya>" prompt, you can just start typing scpi commands. The session will last until you terminate nc with ctrl+c or close the raw PuTTY window.
either you start a netcat session locally with "nc -k -C localhost 5000" on the console, or you start a second PuTTY and open a "raw" type connection to port 5000 on the RedPitaya's ip address. In both cases there will be no "redpitaya>" prompt, you can just start typing scpi commands. The session will last until you terminate nc with ctrl+c or close the raw PuTTY window.
-
- Posts: 3
- Joined: Mon May 23, 2016 8:27 pm
Re: How to SCPI from putty?
Hi,
Both solutions work well. Thanks!
Both solutions work well. Thanks!
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 100 guests