After building the updated API, did you replace the original one in /opt/redpitaya/lib with the new one?tried "digital_led_blink" again - still OK - i.e. the (updated) API generally works fine
recommended memory map address for changed FPGA code
-
Nils Roos
- Posts: 1441
- Joined: Sat Jun 07, 2014 12:49 pm
- Location: Königswinter
Re: recommended memory map address for changed FPGA code
-
HaraldHaug
- Posts: 8
- Joined: Fri Dec 23, 2016 10:26 am
Re: recommended memory map address for changed FPGA code
yes, I did.
In my opinion the application code with the new interface function would not compile successfully if the new librp.so was not there.
In my opinion the application code with the new interface function would not compile successfully if the new librp.so was not there.
-
Nils Roos
- Posts: 1441
- Joined: Sat Jun 07, 2014 12:49 pm
- Location: Königswinter
Re: recommended memory map address for changed FPGA code
Ah, I see, the Makefiles were changed for 0.97.
The Makefiles up to and including 0.96RC3 referenced the librp from the local build (../../lib/) instead of the one that's installed on the system (which lead to much confusion at runtime).
Well, then the problem is different then I thought. I'll have to look into that some more, but I don't know when I'll find the time.
The Makefiles up to and including 0.96RC3 referenced the librp from the local build (../../lib/) instead of the one that's installed on the system (which lead to much confusion at runtime).
Well, then the problem is different then I thought. I'll have to look into that some more, but I don't know when I'll find the time.
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 51 guests