Triggering under high voltage jumper conditions
Posted: Sun Jun 18, 2017 1:19 pm
Hello,
Im trying to config the trigger level under high voltage jumper condition (divided by factor 20). Is the trigger level affected by the command -
rp_AcqSetGain(chanel,state)
If not, what is the range of the trigger level in volts?
Im trying to config the trigger level under high voltage jumper condition (divided by factor 20). Is the trigger level affected by the command -
rp_AcqSetGain(chanel,state)
If not, what is the range of the trigger level in volts?