fw_setenv has no effect

Applications, development tools, FPGA, C, WEB
Post Reply
frederik
Posts: 5
Joined: Tue Jun 09, 2015 10:58 am

fw_setenv has no effect

Post by frederik » Thu Mar 01, 2018 4:35 pm

When I use fw_setenv test_name test_value the Red Pitaya doesn't save the variable to EEPROM. I can verify this by subsequently calling fw_printenv and noticing that test_name has not been set.

What gives?

My /etc/fw_env.config file:

Code: Select all

# Configuration file for fw_(printenv/setenv) utility.
# Up to two entries are valid, in this case the redundant
# environment sector is assumed present.
# Notice, that the "Number of sectors" is ignored on NOR and SPI-dataflash.
# Futhermore, if the Flash sector size is ommitted, this value is assumed to
# be the same as the Environment size, which is valid for NOR and SPI-dataflash

# MTD device name           Device offset   Environment size
/sys/bus/i2c/devices/0-0050/eeprom  0x1800      0x0400
This is also an issue when I try to set the EEPROM variables directly from u-boot using setenv temp_name temp_value and then saveenv. After a reboot, printenv doesn't include temp_name.

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 23 guests