Redpitaya Forum

Dear all,

I would like to use RedPitaya for laser intensity stabilization (pid app). The output range of the RP is from -1V to 1V and my driver modulation just accepts from 0V to 1V. Is there a way (software) to select de desired output voltage range?

Thanks in advance.

In the PID app there is Range drop down window where you can set the range of the output.

amike88 wrote: ↑

Fri Mar 09, 2018 10:52 am

In the PID app there is Range drop down window where you can set the range of the output.

Hi!

In the red pitaya user manual page 19 (see link) defines the range as: 'Range and offset buttons enable quick diagram visualization area setup.'. I don't want to change the visualization setup but the voltage output.

Thanks!

Sorry I was hoping that would do it.