CW Skimmer problem after software upgrade?
Posted: Sat May 19, 2018 8:06 pm
I use CW Skimmer running "SDR receiver compatible with HPSDR". All worked very well until a few days ago. I did the upgrade available in the RP homepage and since then have not been able to get CW Skimmer to work.
If I instead download SDR Transceiver firmware and use with HDSDR or SDR#, all works very well as a receiver.
When running skimmer, the skimmer software detects the RP, the RP ethernet LEDs flash rapidly when skimmer server is started, and skimmer finds the RP and some decoders are shown active but no signals are decoded.
Is it possible the upgrade changed something or is there operator error somewhere?
I have 3 RP and all three act the same way.
Have very high regard for Pavel's fantastic work.
Steve
If I instead download SDR Transceiver firmware and use with HDSDR or SDR#, all works very well as a receiver.
When running skimmer, the skimmer software detects the RP, the RP ethernet LEDs flash rapidly when skimmer server is started, and skimmer finds the RP and some decoders are shown active but no signals are decoded.
Is it possible the upgrade changed something or is there operator error somewhere?
I have 3 RP and all three act the same way.
Have very high regard for Pavel's fantastic work.
Steve