Hi,
I am currently trying to get the ethernet connection running on the bare metal ZYNQ with lwip211 (Vivado 2022.1).
However I am seeing strange behavior. Most of the time the ethernet link can not be established in full and gets reset/set constantly. Strange thing is: when I set a breakpoint after initializing lwip and pause execution for a few seconds and resume afterwards, the link can be established.
I also had to set the link speed to permanent 1000Mbit as auto negotiation with the PHY was not possible (stuck infinitely).
Did anyone get ethernet running on bare metal ZYNQ? Any pitfalls to watch out for? What settings did you use for lwip?
Thanks a lot!
Bare metal ethernet / lwip
-
- Posts: 4
- Joined: Wed Jun 29, 2016 2:12 pm
Re: Bare metal ethernet / lwip
Same issue! does anyone ever get it working with LWIP baremetal? I guess the issue comes from redpitaya PHY since I had already work with LWIP and ZYNQ several times (PHY MARVELL, realteck and TI) without any problem.
Thanks a lot!
Thanks a lot!
-
- Posts: 18
- Joined: Tue Mar 07, 2023 8:49 pm
Re: Bare metal ethernet / lwip
Have you guys ever found an answer to your lwip problem? It clearly is Red Pitaya - related, not a general Zynq problem, since the same application works just fine on another z7020 board. It is also not the Ethernet PHY itself, because OS-based applications (like Pavel Demin's Alpine image) is able to communicate with the board just fine.
-
- Posts: 4
- Joined: Wed Jun 29, 2016 2:12 pm
Re: Bare metal ethernet / lwip
It is totally a PHY issue. LWIP is normally working with MARVELL PHY. I guess you should develop a RP driver for LWIP implementation. Too much
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 2 guests