Hey Guys,
i am fabian, and i have problems with my RP.
I need to run it in Access Point Mode, but i can't find any informations about that anymore (since os0.96)
Is it still possible to use the access point mode?
The other problem is that i could never archieve to run the red pitayas phase shift via SCPI.
So i tried it several times with matlab and labview and was never able that the phase i typed in was brought out on the RP.
in matlab it was possible to cheat by using the arbitrary generator, but in labview even that did not work.
is it my fault or is that a known problem?
Excuse my bad english, i am a german student.
best regards,
fabian
Wifi Access Point and LabView
- redpitaya
- Site Admin
- Posts: 912
- Joined: Wed Mar 26, 2014 7:04 pm
Re: Wifi Access Point and LabView
Hi,
Yes it is still possible.
On 0.96 just start your Red Pitaya, select "Network manager" application (you start it on same way as other applications)
and there you will have settings for the lan network (Static IP or DHCP ) and wifi network (Access point mode or client mode).
Notice: Wifi dongle is needed for AP mode.
Best
Yes it is still possible.
On 0.96 just start your Red Pitaya, select "Network manager" application (you start it on same way as other applications)
and there you will have settings for the lan network (Static IP or DHCP ) and wifi network (Access point mode or client mode).
Notice: Wifi dongle is needed for AP mode.
Best
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 115 guests