Red Pitaya serial communication

Just about everything about Red Pitaya
Post Reply
JoseSP
Posts: 1
Joined: Mon Apr 24, 2017 5:44 pm

Red Pitaya serial communication

Post by JoseSP » Mon Apr 24, 2017 6:01 pm

Hello!

I'm working with Jupyter making codes in phyton to control a 3D printer. I'm trying to communicate with the printer throw serial comunication using the USB port in which you can connect the WiFi dongle, sending G codes to it. There shoud be an error since it doesn't move. Do you know if it's possible to communicate throw that serial USB port?

mahi2712
Posts: 7
Joined: Wed Mar 01, 2017 9:27 am

Re: Red Pitaya serial communication

Post by mahi2712 » Thu May 04, 2017 10:17 am

Hello Jose

For communicating with red pitaya serially just follow these steps:

Install putty or Tera term software.

For Putty software:
Connect your red pitaya with USB.
fill the serial port name and put speed 115200.
Reboot the red pitaya and then you can communicate with the card serially.

For Tera term software:
Connect your red pitaya with USB.
Go to setup and select serial port setup and put Baud rate 115200.
Reboot the red pitaya and then you can communicate with the card serially.

Regards
Gautam

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 27 guests