Redpitaya Forum

Hello!

I'm working with Jupyter making codes in phyton to control a 3D printer. I'm trying to communicate with the printer throw serial comunication using the USB port in which you can connect the WiFi dongle, sending G codes to it. There shoud be an error since it doesn't move. Do you know if it's possible to communicate throw that serial USB port?

Hello Jose

For communicating with red pitaya serially just follow these steps:

Install putty or Tera term software.

For Putty software:
Connect your red pitaya with USB.
fill the serial port name and put speed 115200.
Reboot the red pitaya and then you can communicate with the card serially.

For Tera term software:
Connect your red pitaya with USB.
Go to setup and select serial port setup and put Baud rate 115200.
Reboot the red pitaya and then you can communicate with the card serially.

Regards
Gautam