SCPI & LabView Problems with the Generator function

Just about everything about Red Pitaya
Post Reply
Sahitaz
Posts: 2
Joined: Sat Apr 23, 2016 2:53 pm

SCPI & LabView Problems with the Generator function

Post by Sahitaz » Thu Oct 19, 2017 10:12 am

Hi Guys,

i have some problems with my RP.

If I am using it in my home network, i am able to use the RP in control it, at least with restricted funcitons, via LabView.
If I am trying to use the RedPitaya over a network switch or by using the access point function, I am only able to use the Apps,
but I can not access the RP via LabView. And I can not ping to the RedPitaya by the IP address it tells me.
Why it doesn't show me the right IP, i am not able to connect to the Board?

And when I am trying to build an LabView application with the function generator, it also does not work like i want it.
I am able to generate a sine signal with the correct frequency and amplitude.
But when i try to generate two sine waves with a phase shift, it doesn't work anymore (without phase shift, it works with two sine waves).
I tried to make a workaround with a time delay or the arbitrary function, but there, I can not create any output at all.
Do the SCPI Commands work (via LabView)?

Excuse my bad english, i am from germany.

kind regards
Fabi

amike88
Posts: 89
Joined: Tue Mar 29, 2016 7:41 pm

Re: SCPI & LabView Problems with the Generator function

Post by amike88 » Mon Oct 23, 2017 12:09 pm

Hi,

take a look at this example.

best of luck

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 28 guests