Hello
I have facing some issues with the BODE application for low pass filter at low frequency.
It is a basic RC network with a cutoff at 5khz (nothing rocket science).
If I use the basic BODE application from the bazaar (Bode plotter (0.94-564)) it works well.
If I use the advanced one (preinstalled on the card) I have weird readings.
The phase is not good, and the amplitude decrease as expected and suddenly goes crazy (sawtooth like).
Is this problem known ? Or is there something I miss ?
Ghislain.
BODE application weird readings
-
- Posts: 10
- Joined: Thu Sep 22, 2016 10:14 am
Re: BODE application weird readings
Hello,
So I found the issue. This application seems to work only with LV settings on the Jumper.
It doesn't work with HV or if you set LV+ attenuation on the probes (in1 and in2).
I am satisfied with the result, but I am always a bit worried when using LV, it is easy to overdrive the input ....
Ghislain.
So I found the issue. This application seems to work only with LV settings on the Jumper.
It doesn't work with HV or if you set LV+ attenuation on the probes (in1 and in2).
I am satisfied with the result, but I am always a bit worried when using LV, it is easy to overdrive the input ....
Ghislain.
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 41 guests