I am currently working to drive a half bride with the Red Pitaya’s high frequency output. The MOSFET requires at least 1.8V for an active high and so I desolder the bias resistors to get the whole analog output range of 0-2V. Unfortunately, I forgot, that the FPGA produces always -1V as default voltage to achieve 0V (-1V FPGA+1V BIAS) at the analog output, when it is not driven. I tried to find out where default voltage is defined in the FPGA image files, but without any luck.
Does anybody know, how I can change the FPGA default analog output voltage from -1V to -2V? Or any other suggestions how to tackle this problem?
My aim is achieve again 0V when the fast analog output is not driven.
Thanks in advance!
Just about everything about Red Pitaya
1 post • Page 1 of 1
- Posts: 6
- Joined: Mon Sep 26, 2016 3:54 pm
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 3 guests