RadioBox Receiving signals
Posted: Sat Mar 30, 2024 9:12 am
Hi everyone,
the link for details of the RadioBox leads to an 404 error. I tested the app years ago regarding the transmitting section and it worked fine. I used it for EMC purposes, i.e. to generate 80%-AM signals (unfortunately it is not possible to go up to 80 MHz).
At the moment I also want to get the receiving section running too, but was not successful so far. Is there any detail description of the RadioBox available?
My task is very easy: I have a weak VLF signal about 15-20 kHz and want to make it hearable. So if it is just a switched carrier, it is enough to mix it down to 1 kHz or something else, maybe RadioBox can do this. The selection of the setup parameters in the app are very unclear for me.
I do know, how it would be possible to manage this by an easy to built Audion or self-oscillating Audion. But I want to do this with the Red Pitaya if possible.
Best regards
Dieter
the link for details of the RadioBox leads to an 404 error. I tested the app years ago regarding the transmitting section and it worked fine. I used it for EMC purposes, i.e. to generate 80%-AM signals (unfortunately it is not possible to go up to 80 MHz).
At the moment I also want to get the receiving section running too, but was not successful so far. Is there any detail description of the RadioBox available?
My task is very easy: I have a weak VLF signal about 15-20 kHz and want to make it hearable. So if it is just a switched carrier, it is enough to mix it down to 1 kHz or something else, maybe RadioBox can do this. The selection of the setup parameters in the app are very unclear for me.
I do know, how it would be possible to manage this by an easy to built Audion or self-oscillating Audion. But I want to do this with the Red Pitaya if possible.
Best regards
Dieter