A few days ago Ibought a Stemlab 125-10 Diagnostik kit.
I played aroung with the osciloscope using two XBEE modules as target.
I connected the probes to the digital outputs an wondered why I got a maximum voltage of just 1.1 V.
Even at the supply voltage pins. It should be 3.3 volts. My multimeter measured this voltage.
I changed the vertical gain to 2V/div and tried a 9V battery and measured the above mentioned 1.1 V.
What do I wrong? Why is this like that?
Placement, modules, components and accessories; the ones that exist and the the nice-to-be's
1 post • Page 1 of 1
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 3 guests