Hi,
I would like to use my RP as part of a system which moves considerably. MicroUSB is not a very secure connection and I would like to solder wires to the board and connect it to a rugged connector. I suspect TP10 and TP11 are GND and VCC. However, I am not sure about a SMD component labeled 269L (I am not sure whether it's a diode or capacitor). My worry is by passing this component if I connect power to TP10 and TP11. MY board is V1.0 . I appreciate your help.
Masoud
Power connector
-
- Posts: 789
- Joined: Sat May 23, 2015 5:22 pm
Re: Power connector
According to the page 6 of the board schematics, TP10 is connected to 5VDin before the power protection.
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 23 guests