I'm developing a sinusoidal signal generator with Red Pitaya. I attached the RLT circuit to help understand what i did.
So, first i get the 125MHz clock from ADC, this clock goes to Clocking Wizard (clk_wiz_0), the outputs of this block are: 125MHz clock output (clk_out1) and 250MHz clock output (clk_out2), those clocks are 90º dephased.
I use two DDSs to generate the sinusoidal waves, those DDSs are controlled by the PS(design_1).
And we have the DAC_V2 block, that basically drives the signals out to the phisical DAC.
The circuit for both channel is exactly the same, but i get the first channel working fine and the second with a lot of noise. See the attached pictures.
Hope some one could help me to figure out why this is happening.
Placement, modules, components and accessories; the ones that exist and the the nice-to-be's
1 post • Page 1 of 1
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 3 guests