UART Constraint file.

Placement, modules, components and accessories; the ones that exist and the the nice-to-be's
Post Reply
parveen1
Posts: 1
Joined: Thu Nov 23, 2017 8:19 am

UART Constraint file.

Post by parveen1 » Thu Nov 23, 2017 8:27 am

Hi,
From where i can get full master constraint file for RedPitaya. I need to assign pin for the communication through UART.

Thanks for the help.

amike88
Posts: 89
Joined: Tue Mar 29, 2016 7:41 pm

Re: UART Constraint file.

Post by amike88 » Thu Nov 23, 2017 12:12 pm

If you are talking about PL pins (FPGA pins on the znyq), then you'll find the constraints in the pga/sdc/ folder in the red_pitaya.xdc file.

If you are trying to to modify the PS pins, this pins are fixed, however there are some limited options of selection through vivado. To open vivado go to the fpga/ folder and run $ make project , make sure that PRJ in the Makefile is selected properly (classic, logic,...). This will generate the project for vivado and open it. On how to modify take a look here.

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 19 guests