Code: Select all
Mar 17 10:19:56 kernel arp: 172.25.25.210 moved from 00:26:32:f0:7c:cf to 00:26:32:f0:ff:cf on mvneta1
Code: Select all
address=`awk -F : '$5="FF"' OFS=: /sys/class/net/eth0/address`
ip link add mvl0 link eth0 address $address type macvlan mode passthru
echo 1 > /proc/sys/net/ipv4/conf/all/arp_filter
echo 2 > /proc/sys/net/ipv4/conf/all/rp_filter
$apps_dir/sdr_receiver_hpsdr_122_88/sdr-receiver-hpsdr eth0 1 1 1 1 1 1 1 1 &
$apps_dir/sdr_receiver_hpsdr_122_88/sdr-receiver-hpsdr mvl0 1 1 1 1 1 1 1 1 &
Using SSH I can get to the same device. Below is the ifconfig results
172.25.25.210 & 172.25.25.241
Code: Select all
eth0 Link encap:Ethernet HWaddr 00:26:32:F0:7C:CF
inet addr:172.25.25.241 Bcast:172.25.25.255 Mask:255.255.255.0
inet6 addr: fe80::226:32ff:fef0:7ccf/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:48213 errors:0 dropped:5280 overruns:0 frame:0
TX packets:149232728 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:6192308 (5.9 MiB) TX bytes:1360727636 (1.2 GiB)
Interrupt:30 Base address:0xb000
mvl0 Link encap:Ethernet HWaddr 00:26:32:F0:FF:CF
inet addr:172.25.25.210 Bcast:172.25.25.255 Mask:255.255.255.0
inet6 addr: fe80::226:32ff:fef0:ffcf/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:39001 errors:0 dropped:16 overruns:0 frame:0
TX packets:75092082 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:5524352 (5.2 MiB) TX bytes:80648535661 (75.1 GiB)
Should I disable IPv6 on the device? Is that a bad thing?