Hi to all users, I'm a newbie about redpitaya.
Taking a look to schematics I find 2Vpp and 40Vpp hardware selectable range.
For 2Vpp range I can see 499k+499k resistive partitor while for 40Vpp I can see 10M+200k resistors.
How can I change values for custom full-scale voltage?
Thanks.
Change ADC full-scale range?
- redpitaya
- Site Admin
- Posts: 925
- Joined: Wed Mar 26, 2014 7:04 pm
Re: Change ADC full-scale range?
Hi and thank you for your post.
We do not recommend that you modify the board and lose the warranty, and if you need a bigger input voltage range, just use an additional external attenuator before our board. We also recommend that you run the calibration after that.
We do not recommend that you modify the board and lose the warranty, and if you need a bigger input voltage range, just use an additional external attenuator before our board. We also recommend that you run the calibration after that.
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 2 guests