I have several sources of 122.88 MHz RF that I could use. They are all nearly sinusoidal 50-ohm single-ended output sources. Do I have to feed this through an LVDL line driver chip? I was thinking of using a small pulse transformer for isolation and simply adjusting the signal level from zero up until the ADC triggered reliably.
If a sinusoidal signal won't work, any suggestions for some simple way to make it into a suitable waveform? - perhaps just diode clipping from a high level?
Thanks
Ken
what are people using for external clock?
-
- Posts: 6
- Joined: Fri Dec 03, 2021 2:59 am
-
- Posts: 2
- Joined: Mon Nov 14, 2022 7:57 pm
Re: what are people using for external clock?
Hi Ken, I am a researcher in NMR engineering. I just got my SDRlab (this board needs an external clock signal 122.88MHz to boot) can you send me some pictures and an BoQ for the components that you bought ?
Best regards, DILLMANN
![Very Happy :D](./images/smilies/icon_e_biggrin.gif)
Best regards, DILLMANN
![Very Happy :D](./images/smilies/icon_e_biggrin.gif)
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 4 guests