I just modeled and 3D printed an enclosure for my Red Pitaya.
All the details are here: https://dl.dropboxusercontent.com/u/986 ... losure.pdf
Enjoy !
Just made a 3D printed enclosure with fan for my Red Pitaya
-
- Posts: 2
- Joined: Sat Jan 02, 2016 11:56 am
-
- Posts: 1441
- Joined: Sat Jun 07, 2014 12:49 pm
- Location: Königswinter
Re: Just made a 3D printed enclosure with fan for my Red Pit
Good idea to have external screws for the shell and separate screws for the board.
Do you think PLA would break when inserting the nuts ?
Thanks for sharing !
Do you think PLA would break when inserting the nuts ?
Thanks for sharing !
-
- Posts: 2
- Joined: Sat Jan 02, 2016 11:56 am
Re: Just made a 3D printed enclosure with fan for my Red Pit
No, probably not, might just be a bit harder to have the nuts seated correctly. It may also depend on your printer calibration. the hexagonal holes were designed 0.3 mm wider than the actual nut size. I have not used PLA recently and rely almost exclusively on PETG since months
-
- Posts: 1
- Joined: Sat Jan 16, 2016 5:36 pm
Re: Just made a 3D printed enclosure with fan for my Red Pit
Hi all,
Excellent work. However and as far as the fan is concerned, do you have any part number of Digikey or Mouser since I haven't manage to find this in local distributors/providers.
Excellent work. However and as far as the fan is concerned, do you have any part number of Digikey or Mouser since I haven't manage to find this in local distributors/providers.
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 2 guests