SEPARATED(independent) channel OFFSET and MEASUREMENT SCALE
Posted: Fri Jul 31, 2015 10:55 am
Hello red pitaya team.
I have one red pitaya and one of the things I noticed from the start was
that the offset works simultaneously for both channel RF inputs and also
also we could not set different vertical voltage/division for each channel, like
in a real bench scope.
I think this is a real needed feature so we can overlap signals (that are currently
shown one above the other) by moving them up and down in an independent way.
For example, a 1MHz square wave 2 Vpp, with an excursion from 0 V to 2V, can't
currently be overlapped to a 1MHz sine wave 1Vpp, with a 5V DC component,
because they are separated verticaly and we could not move vertically each of them
independently.
This is a very much have characteristic.
Please, include it in the next SD card image of Red Pitaya.
Thanks to all team,
Miguel Garcia
I have one red pitaya and one of the things I noticed from the start was
that the offset works simultaneously for both channel RF inputs and also
also we could not set different vertical voltage/division for each channel, like
in a real bench scope.
I think this is a real needed feature so we can overlap signals (that are currently
shown one above the other) by moving them up and down in an independent way.
For example, a 1MHz square wave 2 Vpp, with an excursion from 0 V to 2V, can't
currently be overlapped to a 1MHz sine wave 1Vpp, with a 5V DC component,
because they are separated verticaly and we could not move vertically each of them
independently.
This is a very much have characteristic.
Please, include it in the next SD card image of Red Pitaya.
Thanks to all team,
Miguel Garcia