Hello,
I am trying to reconfigure the fpga such that PID module accepts the setpoint value via input chanel 2, input 1 as PID input variable and ouput 1 as PID output. Setpoint value is directly connected to the dac output 2. I made the corresponding changes in the codes red_pitaya_pid.v, red_pitaya_pid_block.sv and red_pitaya_top.sv. I use a cloned file of the original github repository.
I am quite new to redpitaya and fpga programming stuffs. So my question is
Is it enough to just generate bitstream using vivado, copy the red_pitaya.bit file to the fpga folder in redpitaya sd card and change the fpga.config file in the PID app? Is there any other process I have to do.?
FPGA programming to change PID module
-
- Posts: 2
- Joined: Tue Dec 04, 2018 3:13 pm
Re: FPGA programming to change PID module
I have the same issues , I have to make a project based in VIVADO and not to modify in file existed in redpitaya
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 39 guests