Can't Connect to RP (worked fine before)

Applications, development tools, FPGA, C, WEB
Post Reply
reiko_
Posts: 1
Joined: Tue Feb 23, 2021 12:55 am

Can't Connect to RP (worked fine before)

Post by reiko_ » Tue Feb 23, 2021 1:05 am

Sorry if this has already been addressed but I wasn't able to find a solution to my specific issue. I'm unable to connect to a RP board that I was able to connect to before. I had been only connecting to it over wifi until recently. I was able to work with it directly plugged into my computer last week. Now I can't do either (rp-fxxxxxx.local server isn't found and attempts to ssh into it give me "connection refused" when it's connected to the router and "No route to host" when it's directly connected to my laptop. I'm trying to understand if the ip address could have changed but if it did I don't know how to find the new one.)

I checked out the trouble shooting site and the only thing I'm noticing is that the orange LED (access to the SD card) starts off very dim, looks normal for a few seconds, and then stops blinking. I can't remember if this behavior is different than before. I saved a C file that read from a device via UART to the RP, but I don't know why that would have messed things up.

Any tips would be much appreciated!

omereis
Posts: 16
Joined: Mon Jan 27, 2020 1:10 pm

Re: Can't Connect to RP (worked fine before)

Post by omereis » Mon Mar 01, 2021 8:35 am

Your orange LED behaves just like mine, and I am able to connect.
Can you connect the network cable to a router? it works for me.
Maybe you want to connect RP card to a router.

Hope it helps,
Omer.

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 1 guest