Applications, development tools, FPGA, C, WEB
-
fmandoux
- Posts: 4
- Joined: Mon Nov 02, 2015 4:09 pm
Post
by fmandoux » Mon Jan 11, 2016 2:41 pm
Hello,
I am trying to use the RedPitaya in an automatic test environment.
The test script engine runs on a Windows machine and I would like to do the following via Ethernet:
- Program trigger and acquisition settings
- Get trigger status
- Transfer acquisition result to Windows machine
Later I would add other functionalities like controlling the signal outputs but that's another subject.
For doing this I need basically another interface than the browser or SSH. Some server with open ports to access on.
- Is there anything available yet?
- If not, how would you suggest implementing it?
Thanks a lot.
Cheers
Felix
-
fmandoux
- Posts: 4
- Joined: Mon Nov 02, 2015 4:09 pm
Post
by fmandoux » Tue Jan 12, 2016 4:52 pm
Hi All,
I managed to make the SCPI interface more or less run.
Unfortunately I did not find any information about the calibration application to these values.
Are the values I get back with ACQ:SOUR1:DATA? compensated calibration-wise or not?
Thanks.
-
Nils Roos
- Posts: 1441
- Joined: Sat Jun 07, 2014 12:49 pm
- Location: Königswinter
Post
by Nils Roos » Wed Jan 13, 2016 1:09 am
Hi Felix,
Going through the scpi-server's code turns up that it returns calibrated voltages by default. You can switch between calibrated voltages and semi-calibrated sample values with the command "ACQ:DATA:UNITS". Semi-calibrated means that the samples have been compensated for the DC offset only (not gain nor LV/HV setting).
-
fmandoux
- Posts: 4
- Joined: Mon Nov 02, 2015 4:09 pm
Post
by fmandoux » Wed Jan 13, 2016 9:34 am
Thanks for the help.
Cheers
Felix
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 4 guests