Calibration with scopgenpro stucks at HV calibration
Posted: Fri Aug 05, 2016 8:33 pm
Hi,
I tried to calibrate my RP with the "CALIBRATION" function within scopgenpro (OS version 0.95 and 0.96).
Calibrating the LV section went well.
But after clicking "Calibrate" on the step "DC offset for HV", nothing happens any more. Only "Cancel" works.
As you see in the attached screen shot, this is the state where it stucks. Additionally the "Demo mode" message appears.
I read the contents of the E2prom after the LV calibration and after the attempt of the HV calibration as 512 Bytes of binary data, if that helps:
Calibration data after complete LV calibration:
https://dl.dropboxusercontent.com/u/109 ... V_complete
Calibration data after the try of HV DC offset calibration:
https://dl.dropboxusercontent.com/u/109 ... offset_try
Kindly regards,
Hartmut
I tried to calibrate my RP with the "CALIBRATION" function within scopgenpro (OS version 0.95 and 0.96).
Calibrating the LV section went well.
But after clicking "Calibrate" on the step "DC offset for HV", nothing happens any more. Only "Cancel" works.
As you see in the attached screen shot, this is the state where it stucks. Additionally the "Demo mode" message appears.
I read the contents of the E2prom after the LV calibration and after the attempt of the HV calibration as 512 Bytes of binary data, if that helps:
Calibration data after complete LV calibration:
https://dl.dropboxusercontent.com/u/109 ... V_complete
Calibration data after the try of HV DC offset calibration:
https://dl.dropboxusercontent.com/u/109 ... offset_try
Kindly regards,
Hartmut