Page 1 of 1
Errors when cloning git into 'RedPitaya'
Posted: Tue May 16, 2017 1:05 pm
by max paper
I'm trying to run some C applications. I successfully accessed the board but was quickly stopped by an error when cloning the git:
Cloning into 'RedPitaya'...
fatal: unable to access '
https://github.com/RedPitaya/RedPitaya.git/': Could not resolve host: github.com
I was thinking cloning the git "manually" but it is only a temporary solution and I don't know where the file should be put...
Any experience with this kind of error?
(I have no issue to connect to the board).
Thanks.
Max
Re: Errors when cloning git into 'RedPitaya'
Posted: Thu Jul 23, 2020 7:48 am
by jlsdq
Hello
Did you find a solution ?
Could be interessted too
Many Thanks
Re: Errors when cloning git into 'RedPitaya'
Posted: Thu Jul 23, 2020 8:43 am
by omereis
The following worked for me both on Windows and on Ubuntu:
Code: Select all
$ mkdir <my_rp_dir>
$ cd <my_rp_dir>
$ git clone https://github.com/RedPitaya/RedPitaya .
Note: It's easy t miss the dot at the end of the statement. It worked for me without it, though.
Make sure you have write permissions, for example by executing
. If you are trying this on the Red Pitaya Card, you ma want to run
to enable writing authorization.
Hope it helps
Omer.
Re: Errors when cloning git into 'RedPitaya'
Posted: Mon Jul 27, 2020 3:19 pm
by kevin.falque
Hi everyone,
I also face problems when I want to clone into RedPitaya.
I follow the instructions on the Red Pitaya site. And i get the error message
"fatal: unable to access '
https://github.com/RedPitaya/RedPitaya.git/': Could not resolve host: github.com".
Any reply on this posts could help.
Thanks a lot.
Falque
Re: Errors when cloning git into 'RedPitaya'
Posted: Thu Jan 13, 2022 4:15 pm
by Hans1905
Hi,
did you solve the problem? Can you give me some advice?
Thanks
Re: Errors when cloning git into 'RedPitaya'
Posted: Thu Mar 31, 2022 2:08 am
by Daniel_s
I had the same issue.
It seems that the problem could have originated from either proxy settings or the internet connection not actually reaching the RP-board when in direct ethernet connection. The solution for me (on windows) was to share the incoming internet connection with "other users".
The issues #164 and #165 on github: [
https://github.com/RedPitaya/RedPitaya/issues/165] were useful to solve it.