My /etc/fw_env.config file:
This is also an issue when I try to set the EEPROM variables directly from u-boot using setenv temp_name temp_value and then saveenv. After a reboot, printenv doesn't include temp_name.
Code: Select all
# Configuration file for fw_(printenv/setenv) utility. # Up to two entries are valid, in this case the redundant # environment sector is assumed present. # Notice, that the "Number of sectors" is ignored on NOR and SPI-dataflash. # Futhermore, if the Flash sector size is ommitted, this value is assumed to # be the same as the Environment size, which is valid for NOR and SPI-dataflash # MTD device name Device offset Environment size /sys/bus/i2c/devices/0-0050/eeprom 0x1800 0x0400