Set up Istructions for OpenHPSDR mRX PS

Applications, development tools, FPGA, C, WEB
Post Reply
GregMew
Posts: 6
Joined: Thu May 24, 2018 10:40 am

Set up Istructions for OpenHPSDR mRX PS

Post by GregMew » Fri Jun 29, 2018 2:02 pm

Hi
I have Red Pitaya talking to the above software and want to use the I2C data ports on the E2 Port of the Red Pitaya (This interface is designed by Peter DC2PD) as per pavel-demin.github.io/red-pitaya-notes/sdr-transceiver-hpsdr/

I have looked a the I2C port with a logic analyser and can see no trafic on this port at all.

Is there a setup on Open HPSDR that needs to be enabled to allow I2C traffic?

Regards

Greg

pavel
Posts: 789
Joined: Sat May 23, 2015 5:22 pm

Re: Set up Istructions for OpenHPSDR mRX PS

Post by pavel » Fri Jun 29, 2018 2:42 pm

Hi Greg,

Your logic analyzer should see some I2C traffic when the SDR transceiver compatible with HPSDR is started on the Red Pitaya board. When the program running on the Red Pitaya board is started, it tries to contact several I2C addresses to discover the connected I2C devices.

If no I2C device known to the program running on the Red Pitaya board is discovered at startup, then the program doesn't send anything to the I2C bus after the initial discovery phase.

There is nothing to be enabled in PowerSDR mRX PS.

Best regards,

Pavel

GregMew
Posts: 6
Joined: Thu May 24, 2018 10:40 am

Re: Set up Istructions for OpenHPSDR mRX PS

Post by GregMew » Sun Jul 01, 2018 12:34 pm

Thanks Pavel

That explains why I could not see any traffic once the RP had started.

I have looked on switch on and can see some activity so all good.

Regards

Greg

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 19 guests