JTAG Connection (again)
Posted: Mon Feb 18, 2019 6:49 pm
Hey guys,
I would like to program the my Stemlab 125-14 v.1.0 using the JTAG connector on the board, so I can do it directly from Vivado (instead of doing it over ssh) and also debug my designs using the Integrated logic analyzer of Vivado.
I bought a Digilent JTAG-HS3 USB cable:
https://reference.digilentinc.com/_medi ... hs3_rm.pdf
This cable unfortunately does not really fit on the pins on the board. Therefore I would like to solder a little adapter.
I've been browsing the forum and wiki now to find out, which JTAG pins on the board are which but cannot find any specification. Also in the development schematics it doesn't say anything about which JTAG pin in the schematic corresponds to which physical pin on the board
https://redpitaya.readthedocs.io/en/lat ... /shem.html
If someone could help me out with the correct order of the JTAG pins on the board, I would appreciate it very much. Thx
I would like to program the my Stemlab 125-14 v.1.0 using the JTAG connector on the board, so I can do it directly from Vivado (instead of doing it over ssh) and also debug my designs using the Integrated logic analyzer of Vivado.
I bought a Digilent JTAG-HS3 USB cable:
https://reference.digilentinc.com/_medi ... hs3_rm.pdf
This cable unfortunately does not really fit on the pins on the board. Therefore I would like to solder a little adapter.
I've been browsing the forum and wiki now to find out, which JTAG pins on the board are which but cannot find any specification. Also in the development schematics it doesn't say anything about which JTAG pin in the schematic corresponds to which physical pin on the board
https://redpitaya.readthedocs.io/en/lat ... /shem.html
If someone could help me out with the correct order of the JTAG pins on the board, I would appreciate it very much. Thx