Hi guys,
I have noticed that whenever I run the "Generate and Acquire Waveform" VI, the signal generated can be seen on the oscilloscope but the measurement array in the LabVIEW program itself doesn't seem to give out any output and so, only a noise-like signal gets shown on the waveform graph in the front panel. I am using Red Pitaya 125.14 DAQ board. Has anybody noticed the same? Any idea as to how to correct it?
Thanks in advance for any pointers/solutions.
Issue with a LabVIEW VI
-
- Posts: 1
- Joined: Wed Oct 28, 2015 4:28 pm
Re: Issue with a LabVIEW VI
Hi Arpit,
are you still experiencing this problem or have you found a solution or workaround? You could post your VI and I would take a look.
Best regards
Markus
are you still experiencing this problem or have you found a solution or workaround? You could post your VI and I would take a look.
Best regards
Markus
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 36 guests