Page 2 of 2

Re: Problème to use redpitaya 122/66 sdr

Posted: Fri May 29, 2020 7:23 pm
by chrisdgy
sorry was in french ...... Pavel, I misspoke!
the new new sd card ... I copy the files and folders from the dezziper file stemlab-sdr-alpine-3.9-armv7-20191025
when i turn on the rpp the green and blue leds are on and the last led 'led number 0 "at the end flashes!

when when I launch the mop with bone 0-98.5
the green and blue are on and the red led flashes more orange at times the one next to the red

and once again with the other sd cards I cannot connect neither in ethernet nor via ip

chris

Re: Problème to use redpitaya 122/66 sdr

Posted: Fri May 29, 2020 8:30 pm
by pavel
the new new sd card ... I copy the files and folders from the dezziper file stemlab-sdr-alpine-3.9-armv7-20191025
when i turn on the rpp the green and blue leds are on and the last led 'led number 0 "at the end flashes!
I don't see any problem here. The blinking LED number 0 is perfectly OK. This is exactly how it should work. Please continue with this micro SD card.

Re: Problème to use redpitaya 122/66 sdr

Posted: Sat May 30, 2020 5:44 am
by chrisdgy
hello, Pavel.

indeed I finally managed to connect last night! certainly it was necessary to refresh the web page! because otherwise not connected! but this card was formatted in mbr format and win 95 fat 32! I will check with another card if this is the cause? win 95? or just refresh the web page?

I will do that a little later.

well now i will also try with the other alpine version arm07 2019-11-25 ..!

now maybe you have a solution to use wifi on a usb stick or ethernet with the redpitaya plugged directly into the pc

good thanks for this help.

cordially Chris

Re: Problème to use redpitaya 122/66 sdr

Posted: Sat May 30, 2020 8:52 am
by pavel
indeed I finally managed to connect last night!
Great!
well now i will also try with the other alpine version arm07 2019-11-25 ..!
I don't have version 2019-11-25 for STEMlab 122.88-16 SDR.
now maybe you have a solution to use wifi on a usb stick or ethernet with the redpitaya plugged directly into the pc
Some details on network configuration can be found in my notes at this link.

For the direct Ethernet connection, the IP address of the Ethernet port of the PC should be manually set to an address in the 192.168.1.x network. For example, 192.168.1.101.