Cmd line lcr gives wrong values

Applications, development tools, FPGA, C, WEB
Post Reply
causebirdscanfly
Posts: 1
Joined: Wed Jul 08, 2020 12:39 pm

Cmd line lcr gives wrong values

Post by causebirdscanfly » Thu Jul 09, 2020 5:29 pm

Hej,

I have the following problem using the lcr extension module:

Since there is no timestamp included in the measurements within the webapp, I used python to establish a SSH connection with the redpitaya 125-14. Then I used the lcr cmd line tool to measure values and added a timestamp within python. Everything worked out until I wanted to check the measured values:
I connected a 1 Ohm resistor. Via the webapplication of the lcr meter this was measured in an accurate way. In the cmd line tool however, I get really buggy values for the resistance, that are up to one order of magnitude different than the real resistance.

I used the following settings and have the right channel selcted:
lcr 1 0.4 0 0 1 0 0 0 2 0 1000 1000 0 0

I wold really appreciate some help.

Thank you!

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 26 guests