RF Input vs Scope Voltage Level
Posted: Mon Sep 14, 2020 6:43 am
Hi All,
I'm reading RF input signal using rp_AcqGetDataV function on a 125-14 board.
It's working, based on the C code here:
https://redpitaya.readthedocs.io/en/lat ... exm1.html.
However, on the Scope application, and on an external scope, the voltage is much different.
For example, when injecting 2v peak-to-peak, the output sine from a generator, rp_AcqGetDataV reading show 40mV peak-to-peak.
Please note that the board is calibrated, and IN1 channel is set to HV.
What am I missing?
Thanks in advance,
Omer
I'm reading RF input signal using rp_AcqGetDataV function on a 125-14 board.
It's working, based on the C code here:
https://redpitaya.readthedocs.io/en/lat ... exm1.html.
However, on the Scope application, and on an external scope, the voltage is much different.
For example, when injecting 2v peak-to-peak, the output sine from a generator, rp_AcqGetDataV reading show 40mV peak-to-peak.
Please note that the board is calibrated, and IN1 channel is set to HV.
What am I missing?
Thanks in advance,
Omer