Hello,
I am running into a problem with controlling the LEDs using the monitor command line utility with the 122-16 running SDRlab_122-16_OS_1.03-6_stable.
I ssh into the 122-16, load the v0.94 bit file (not sure if this is even needed), and then type the command 'monitor 0x00000030 0x00000001' (this should turn on LED0).
I have no problems doing this on the 125-14, and can't get it to work following the same procedure on the 122-16.
Any suggestions?
Thanks in advance!
SDRlab 122-16 Register Control of LEDs
- redpitaya
- Site Admin
- Posts: 901
- Joined: Wed Mar 26, 2014 7:04 pm
Re: SDRlab 122-16 Register Control of LEDs
Hi there, Thank you for posting.
This should work ok, we tested on 1.04-7 OS version.
cat /opt/redpitaya/fpga/fpga_0.94.bit > /dev/xdevcfg
monitor 0x40000030 0x00000001
monitor 0x40000030 0x00000000
This should work ok, we tested on 1.04-7 OS version.
cat /opt/redpitaya/fpga/fpga_0.94.bit > /dev/xdevcfg
monitor 0x40000030 0x00000001
monitor 0x40000030 0x00000000
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 23 guests