Applications, development tools, FPGA, C, WEB
3 posts • Page 1 of 1
- Posts: 656
- Joined: Sat May 23, 2015 5:22 pm
No, it is not possible.
- Is it possible to set the IQ bitmask via gr-osmosdr? Like you would for the sdr_transciver_wide project?
The IQ bitmask parameter is only implemented in sdr-transceiver-wide. The gr-osmosdr block is only compatible with sdr-transceiver that does not have the IQ bitmask parameter.
The IQ bitmask parameter was added to the wideband SDR transceiver for transmitting and receiving complex baseband signals. This functionality was requested in this GitHub issue.
- Also, is there a description somewhere of what exactly IQ mask does?
This use case is described at the following link:
http://pavel-demin.github.io/red-pitaya ... nd-signals
The two bits of the IQ bitmask enable the two inputs and two outputs of the Red Pitaya board. If the IQ bitmask is set to 1, then only IN1 and OUT1 are enabled. If the IQ bitmask is set to 3, then both inputs and both outputs are enabled.
Yes, it is possible to use the gr-osmosdr blocks for both channels.
- Finally, in designs that support both channels like sdr_transciever, is it possible to use gr-osmosdr for both channels?
The channels are selected by setting the port to 1001 or 1002. 1001 is for IN1 and OUT1. 1002 is for IN2 and OUT2.
For example, to use two inputs, you will need two gr-osmosdr source blocks, one with the port set to 1001 and the other one with the port set 1002.
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 3 guests