Page 1 of 1

Ext trigger dead time of 0.5 ms

Posted: Wed Sep 15, 2021 2:29 pm
by aba_phi
Hi y'all,

there seems to be little information on the topic, but external triggering of the signal generator and the acquisition has a dead time after triggering of 0.5 ms.
I am using the AWG in burst mode as an arbitrary pulse generator.
a post mentioning the dead time can be found here:

the post mentions, that the dead time might be set voluntarily and might be configurable.
Any ideas on what the easiest way would be to configure that (e.g. lower the dead time)?