compilation problem

[fromage]

Hey community,
my last build tries failed, although the full build had worked before.
With the actual code copied from git I get the following error.

Code: Select all

make[2]: Leaving directory `/home/quasirio/RedPitaya/FPGA/release1/fpga'
cp release1/fpga/vivado/red_pitaya.sdk/SDK/SDK_Export/fsbl/Debug/fsbl.elf /home/quasirio/RedPitaya/build/memtest.elf
cp release1/fpga/vivado/red_pitaya.runs/impl_1/red_pitaya_top.bit /home/quasirio/RedPitaya/build/fpga.bit
cp: cannot stat ‘release1/fpga/vivado/red_pitaya.runs/impl_1/red_pitaya_top.bit’: No such file or directory
make[1]: *** [install] Error 1
make[1]: Leaving directory `/home/quasirio/RedPitaya/FPGA'
make: *** [build/fpga.bit] Error 2

real	3m27.752s
user	2m24.957s
sys	0m18.830s

I run the compilation by the following code:

Code: Select all

rm -rf RedPitaya && git clone https://github.com/RedPitaya/RedPitaya.git && cd R
edPitaya && source /opt/Xilinx/Vivado/2013.3/settings64.sh && export CROSS_COMPI
LE=arm-xilinx-eabi- && make

Are there any suggestions how to solve this?

Best Florian

[Nils Roos]

Hi Florian,
Your build failed because the fpga bitstream was not found. When exactly did you try this the last time ?
(there was a bad commit in the public repo which made the fpga generation fail. It was active between Feb 10th, 16:30 and Feb 11th, 08:36)

I just verified that the current master has no problem with the fpga bitstream build.

If it is still failing with a fresh checkout, it would help if you could capture more - preferably all - of the output.

[fromage]

Hey Nils,
I tryed it again today and could compile without problem.
Thanks for your help .

[fromage]

An other compilation problem occured today.
Last weeks the compilation worked, but today I got this error .

Code: Select all

>>> avahi 0.6.31 Extracting
gzip -d -c /home/quasirio/RedPitaya/OS/buildroot/buildroot-2014.02/dl/avahi-0.6.31.tar.gz | tar --strip-components=1 -C /home/quasirio/RedPitaya/OS/buildroot/buildroot-2014.02/output/build/avahi-0.6.31  -xf -

gzip: /home/quasirio/RedPitaya/OS/buildroot/buildroot-2014.02/dl/avahi-0.6.31.tar.gz: not in gzip format
tar: This does not look like a tar archive
tar: Exiting with failure status due to previous errors
make[2]: *** [/home/quasirio/RedPitaya/OS/buildroot/buildroot-2014.02/output/build/avahi-0.6.31/.stamp_extracted] Error 2
make[2]: Leaving directory `/home/quasirio/RedPitaya/OS/buildroot/buildroot-2014.02'
make[1]: *** [buildroot-2014.02/output/images/rootfs.cpio.uboot] Error 2
make[1]: Leaving directory `/home/quasirio/RedPitaya/OS/buildroot'
make: *** [build/uramdisk.image.gz] Error 2

[Nils Roos]

This post probably applies to your situation, too.