Zynq from Scratch: Boot
Posted: Wed Jul 08, 2015 5:29 pm
Hi guys
I was planning to use the redpitaya for a "Zynq from Scratch" plattform using this guide: zynqfromscratch.com
After some reading the problem occured: How is the boot mode set on the redpitaya? On the ZedBoard one can change it using jumpers. Hence the Redpitaya has no such bootjumpers I guess it is hard set to either SD Card or QSPI. Has anybody dealed with that before? I want to use JTAG.
Cheers,
Noah
Again the schematics would be _reeaaallly_ helpful here @redpitaya
I was planning to use the redpitaya for a "Zynq from Scratch" plattform using this guide: zynqfromscratch.com
After some reading the problem occured: How is the boot mode set on the redpitaya? On the ZedBoard one can change it using jumpers. Hence the Redpitaya has no such bootjumpers I guess it is hard set to either SD Card or QSPI. Has anybody dealed with that before? I want to use JTAG.
Cheers,
Noah
Again the schematics would be _reeaaallly_ helpful here @redpitaya