Hi guys
I was planning to use the redpitaya for a "Zynq from Scratch" plattform using this guide: zynqfromscratch.com
After some reading the problem occured: How is the boot mode set on the redpitaya? On the ZedBoard one can change it using jumpers. Hence the Redpitaya has no such bootjumpers I guess it is hard set to either SD Card or QSPI. Has anybody dealed with that before? I want to use JTAG.
Cheers,
Noah
Again the schematics would be _reeaaallly_ helpful here @redpitaya
Zynq from Scratch: Boot
-
- Posts: 33
- Joined: Fri Jan 23, 2015 9:53 am
- Location: Zurich
Re: Zynq from Scratch: Boot
So i got hold of a jtag probe (the HS2 from Digilent bought from farnell. correct pinout and fits perfectly!).
With no SD inserted I can now follow the tutorials on zynqfromscratch.com
So contact me, if you have any troubles.
Cheers,
Noah
With no SD inserted I can now follow the tutorials on zynqfromscratch.com
So contact me, if you have any troubles.
Cheers,
Noah
-
- Posts: 1441
- Joined: Sat Jun 07, 2014 12:49 pm
- Location: Königswinter
Re: Zynq from Scratch: Boot
Hey, good to know - I wasn't sure whether boot from jtag was supported or not.
Thanks for finding out ;O)
Thanks for finding out ;O)
-
- Posts: 5
- Joined: Fri Apr 20, 2018 2:02 pm
Re: Zynq from Scratch: Boot
Hi,
I want to boot the redpitaya from QSPI. i think it has micron SPI flash. which Part number should i need to select while adding configuration memory device in vivado Hardware manager?
can anyone help?
Thanks
Abinaya
I want to boot the redpitaya from QSPI. i think it has micron SPI flash. which Part number should i need to select while adding configuration memory device in vivado Hardware manager?
can anyone help?
Thanks
Abinaya
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 98 guests