I'm writing a C program to control the acquisition and generation of signals. They are modified version do the generate and acquire program provided in the repo and I'm integrating both the acquisition and generation in the same program. I managed to make it work but I'm also running into some problems.
Something that I noticed is that when I run my program it resets the ams registers ( I use # monitor -ams) If then I run the provided software for the oscilloscope or the signal generator the monitor -ams command produces the right results. I'm pretty sure that I'm not using the addresses of the ams registers, only the osc and awg.
ams register inadvertently reset
-
- Posts: 67
- Joined: Wed May 28, 2014 12:15 pm
Re: ams register inadvertently reset
Have you manage to find out what (which part of the code) is causing this behaviour?
-
- Posts: 11
- Joined: Wed Jul 09, 2014 4:25 pm
Re: ams register inadvertently reset
No, I'm usign the HK, scope and ASG registers. I've even succesfully changed the behavoir of some registers for my own purpose by modifying the verilog code. Beyond that, I'm not accessing the rest of registers.
I'll have a look at the verilog code to see if something is interfering with other registers but nowadays my code is working ok.
Regards
Andoni
I'll have a look at the verilog code to see if something is interfering with other registers but nowadays my code is working ok.
Regards
Andoni
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 94 guests