constraints files for STEMlab 125-10?

dedicated to the FPGA topics for all Red Pitaya programmers
Post Reply
iamtheweenus
Posts: 2
Joined: Thu Jan 27, 2022 7:35 pm

constraints files for STEMlab 125-10?

Post by iamtheweenus » Thu Jan 27, 2022 8:21 pm

Hello,

I just bought a STEMLab 125-10 and am new to FPGA so please excuse me if this are dumb questions. I recently downloaded the board and constraint files from github. Vivado identifies the board files as a STEMab-14. Secondly, I imported the .xdc files from the examples (Led Blinker/Frequency Counter) and noticed that the ADC inputs are 14-bits but my board is obviously 10-bit. Do I need to change this?

Please let me know if these questions aren't clear.

Thanks,

Chris

juretrn
Posts: 104
Joined: Tue Nov 16, 2021 11:38 am

Re: constraints files for STEMlab 125-10?

Post by juretrn » Fri Jan 28, 2022 9:37 am

Hi Chris,

Red Pitaya 125-10 and 125-14 (on Zynq 7010) are the same as far as FPGA is concerned.
The only difference is that the 4 LSB pins are connected to ground; therefore the constraint files are valid for both models.

EDIT: please post such questions under the new "FPGA related questions" subforum so it's easier for me to find them in the future.

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 2 guests