Build a bitstream from Vivado?

dedicated to the FPGA topics for all Red Pitaya programmers
Post Reply
f5mzn
Posts: 1
Joined: Sun Feb 13, 2022 12:23 pm

Build a bitstream from Vivado?

Post by f5mzn » Sun Feb 13, 2022 1:03 pm

Hi-

In order to teach myself with red pitaya, I'd like to make some tiny modifications of the sdr_transceiver_122_88 project (thanks to Pavel for providing it).

I have been able to generate the project file in order to open it in the `Vivado` GUI and I wondered what is the best way to generate the bitstream. For now, I manually modify the tcl files from the project folder (reflecting the mods I done in GUI) and then re-launch a `make NAME=sdr_transceiver_122_88 bit` (after a clean) which is quite a long and impractical process. Is there something better to do? Sorry it this is a stupid question... I might miss something obvious! :)

Thanks and best regards.

Olivier.

pavel
Posts: 790
Joined: Sat May 23, 2015 5:22 pm

Re: Build a bitstream from Vivado?

Post by pavel » Mon Feb 14, 2022 9:14 pm

If you prefer to use the GUI, then it is possible to do all editing and bitstream generation in the Vivado GUI.

Here are the steps that I use for this type of workflow:
  • build Vivado project

    Code: Select all

    make NAME=sdr_transceiver_122_88 PART=xc7z020clg400-1 xpr
  • open project in Vivado GUI

    Code: Select all

    vivado tmp/sdr_transceiver_122_88.xpr
  • modify project in Vivado GUI
  • generate bitstream in Vivado GUI

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 5 guests