Hello,
I'm currently working in a project where I'm writing my own FPGA program for the Red Pitaya STEMlab 125-14 .
So far using the fast ADC and DAC is working out fine, but I also need to use 2 channels of the slow DAC outputs. I can't find any information in the documentation how to control the output voltage. The FPGA constrains contain 4 "dac_pwm_o" pins, but I can't find out how to design the PWM signal.
By playing around with different PWM signals I was able to generate a saw-tooth-like voltage, but I would like to be able to adjust a stable output voltage between the 0 to 1.8 V. Is there any information available on how to achieve that?
Thanks,
Finn
Using the slow DAC from FPGA
-
- Posts: 119
- Joined: Tue Nov 16, 2021 11:38 am
Re: Using the slow DAC from FPGA
Hi,
the current FPGA implementation uses a PDM-based slow DAC (red_pitaya_pdm). The configuration for this module is 4x 8 bit values, where 0 represents 0 V and 255 is 1.8 V. The output of that PDM is then passed through an RC filter, which should give an appropriate DC signal.
the current FPGA implementation uses a PDM-based slow DAC (red_pitaya_pdm). The configuration for this module is 4x 8 bit values, where 0 represents 0 V and 255 is 1.8 V. The output of that PDM is then passed through an RC filter, which should give an appropriate DC signal.
-
- Posts: 2
- Joined: Tue Oct 25, 2022 4:15 pm
Re: Using the slow DAC from FPGA
Hi,
thanks for your fast reply and your hints! I got the slw DAC working.
thanks for your fast reply and your hints! I got the slw DAC working.
-
- Posts: 3
- Joined: Mon Mar 20, 2023 2:28 pm
Re: Using the slow DAC from FPGA
Hello, I see that the slow DAC has a 12-bit resolution. Why is the PDM module only 8 bits ?juretrn wrote: ↑Fri Dec 16, 2022 5:57 pmHi,
the current FPGA implementation uses a PDM-based slow DAC (red_pitaya_pdm). The configuration for this module is 4x 8 bit values, where 0 represents 0 V and 255 is 1.8 V. The output of that PDM is then passed through an RC filter, which should give an appropriate DC signal.
-
- Posts: 119
- Joined: Tue Nov 16, 2021 11:38 am
Re: Using the slow DAC from FPGA
What "slow DAC" are you thinking of?
The one in question is a single line that gets passed through an analog filter, which gives the appropriate DC voltage.
Are you looking at the Zynq's on-board XADC module? That is an ADC only.
The one in question is a single line that gets passed through an analog filter, which gives the appropriate DC voltage.
Are you looking at the Zynq's on-board XADC module? That is an ADC only.
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 1 guest