The "Hardware Specifications" described that the Auxiliary analog output channels can used as PWM mode,
But no SCPI command can be foud for this function, only the RF out channel can set to PWM mode,
Is there some majic to make the Auxiliary analog output channels works on PWM?
How to set the Auxiliary analog output channels works on PWM
-
- Posts: 6
- Joined: Mon Sep 12, 2016 1:06 pm
-
- Posts: 1441
- Joined: Sat Jun 07, 2014 12:49 pm
- Location: Königswinter
Re: How to set the Auxiliary analog output channels works on
You misinterpret the specification, it says that the aux analog outputs generate the analog signal by low-pass filtering a PWM waveform.
So they are always operating in PWM mode, but you don't see the PWM at the ouputs.
So they are always operating in PWM mode, but you don't see the PWM at the ouputs.
-
- Posts: 6
- Joined: Mon Sep 12, 2016 1:06 pm
Re: How to set the Auxiliary analog output channels works on
Oh, I see, Thanks a lot!Nils Roos wrote:You misinterpret the specification, it says that the aux analog outputs generate the analog signal by low-pass filtering a PWM waveform.
So they are always operating in PWM mode, but you don't see the PWM at the ouputs.
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 113 guests