Page 1 of 1

Questions about sample speed and use of two boards in parallel.

Posted: Sun May 27, 2018 11:16 am
by Andres_S

I am currently developing a data acquisition system to study ultrasounds and the Red Pitaya hardware looks like an interesting choice, but I have a few questions about it:

-Can it really have a continuous sampling speed of 125 MS/s or there is a stop after the buffer is filled? In the case of the non-continuous acquisition: how fast can it sample if I want (hypothetically) to take measurements during 30-60 seconds without losing data?

-I also need to take measurements from 4 channels, since each board only has 2 input channels, would it be possible to use two of them in parallel connected to the same computer via labview?

Best regards.