Page 1 of 1

Stemlab 14-bit fails on startup

Posted: Fri Jun 01, 2018 2:52 pm
by n4zr
My new unit typically fails the first time it is powered up. It goes through the standard start-up sequence, including the flashing red "heartbeat" indicator, followed by a 1/2-second illumination of the 4th (yellow) LED. After that the heartbeat stops. Typically, if I disconnect and reconnect the power one or more times, I can get it to keep running, and it then appears to work normally.

I am using the Stemlab with Pavel Demin's latest HPSDR compatible 8-band receiver, and aside from this quirk it works well. Any advice?

Pete Smith N4ZR

Re: Stemlab 14-bit fails on startup

Posted: Tue Jun 05, 2018 1:45 pm
by redpitaya
Hi,
please try with another SD card & power supply and official SD card image.
http://redpitaya.readthedocs.io/en/late ... Dcard.html
If this will not help and board is still in warranty, please contact our support.
thank you, Red Pitaya team