Hello RP Experts,
I am a newbie to RP and FPGA, Been working with it for 1 Month.
I am trying to develop ethernet project, where i have 32 AXI stream counter on PL, and i would like to send the count data to PC through Ethernet UDP Protocol.(Speed needed 11 mbits per sec)
I have been following Pavel demin and other developers who are working on many projects, trying to understand bits and piece but i have hard time understanding.
The things i have understood so far.
1.My data has to take path: AXI counter ->AXI FIFO -> DMA -> RAM -> Ethernet DMA/Controller -> PC
I have achived data storage in ram through PL DMA.
2.Now after following Pavel demin, he is working with macb linux drivers to configure ethernet.
Ok so now i need to get into linux development.
3.I have understood i need to configure ethernet controller device tree by following a video from Xilinx "xilinx.com/video/soc/linux-networking-focused-on-ethernet.html" .
4.I have been studing about linux development from various sources online but no luck
I have been following youtuber "Mohammadsadegh Sadri".
It seems i have all bits of information, but i have trouble connecting and start development.
Could anyone help be me by providing a simple referance project, or some links which would help me connect everything properly.
Thank you in advance for your help.
Looking forward for you reply
Just about everything about Red Pitaya
1 post • Page 1 of 1
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 2 guests